BPDU Guard Recovery M24PWR Panasonic

Prosedur ini menutup port sementara dalam koneksi loop dan menghindari terjadinya Looping menggunakan paket BPDU yang dikirim sementara pada protocol STP yang sebelumnya diaktifkan
pada gambar diatas adalah contoh terjadinya loop connection (a)dan gambar bawah port yg sudah dishutdown (otomatis)/disable.
3

  •  Connect to the Web management screen of Switch-M24PWR.
  •  Set Switch-M24PWR.
    1. Enable the STP global setting.
      1. Select “Advanced Config” → ”Spanning Tree Config” → ”STP Global Config” (i → ii → iii).
      2.  Change “STP Global Status” to ”Enabled” (iv).
      3.  Apply the change by “Apply” (v)
         
         
      5
      • Enable the BPDU guard function.
      • Enable the BPDU guard function and the automatic recovery function.

        1) Select “CIST Basic Port Config” (i).
        2) Change “BPDU Guard Recovery Status” to “Enabled” (ii).
        3) Apply the change by “Apply” (iii).
        4) Select “Select All” (iv).
        5) Change “BPDU Guard” to “Enabled” (v).
        6) Apply the change by “Apply” (vi).
        7) Confirm that “BPDU Guard“ is changed to “Enabled” (vii).

         4
      3) Connect the loop and confirm that the port shuts down

      Save the settings.

      1) Select “System Tools”. → ”Save Current Config”(i → ii).
      2) Save the settings by “Save Current Config”(iii).
      3) Execute saving by “OK”(iv).
      4) Confirm that the settings are saved successfully (v).

      Execute operation check.

      Confirm that the port automatically shuts down when the loop is connected

    Untuk Tutor Video bisa dilihat:


    • /mf

0 Response to "BPDU Guard Recovery M24PWR Panasonic"

Post a Comment

Komentar Saudara/i sangat bermanfaat untuk membangun Blog ini,Terimakasih
Your comments are very useful for building this blog, thank you